820,00€ (+ 21% VAT)
AEM’s Infinity Plug & Play Adapter Harnesses for the 2016-’17 Polaris RZR XP Turbo (PN 30-3822) is for use with the Infinity Powersports ECU (PN 30-7112).
Complete Stand Alone Engine Control
When combined with AEM’s Plug & Play Adapter Harness, the Infinity completely replaces the RZR XP Turbo’s factory ECU and installs quickly using all supplied hardware and sensors. A base map for the engine is included to speed up the tuning process.
Tune it Once for Sea Level and Altitude
The provided RZR base calibration is setup to allow for one time tuning of the VE table for all altitudes. It can be tuned at sea level and driven to high altitudes all while keeping AFRs on target without feedback.
Complete Plug & Play Systems for All RZR Models
A wideband AFR sensor and ignition coil driver are included in each Plug & Play RZR XP Turbo kit to ensure quick installation. Connections for the factory sensors are included on each Plug & Play wiring harness. The Infinity ECU supports the factory injectors and injector upgrades through the Wizard in the software. The XP Turbo’s Drive-by-Wire and boost control is supported by the Infinity ECU.
Full Dashboard Functionality
The Infinity ECU integrates with the RZR’s CANbus system to retain full dashboard functionality on each vehicle.
AWD Control is Fully Supported
AWD control is supported through the Infinity ECU to retain the RZR’s formidable off road capabilities.
Closed-Loop Wideband Feedback Control
The Infinity ECU includes an on-board UEGO wideband air/fuel ratio (AFR) controller. A Bosch 4.2LSU UEGO sensor (PN 30-2001) is included with each Plug & Play kit.
Plug & Play Harness with Expansion Port
AEM’s sealed, weatherproof Plug & Play harness for Polaris RZRs includes an AEMnet port for communication with other AEMnet enabled devices.
An expansion port with a weatherproof 12-pin connector is included in the Plug & Play Adapter Harness for adding common aftermarket sensors including fuel and/or oil pressure (30-2130-150 150 PSI) and ethanol content (ethanol content sensor PN 30-2200 sold separately). The expansion port also includes a sensor ground, 5v reference, power from relay and switched inputs for boost target, etc.